What is the costs of materials and labor versus cost savings of heat and cooling with the Batt-Brackets for a standard home?

Installing InSoFast Batt-Brackets costs approximately $0.89 per square foot for brackets plus $1.00 to $2.20 per square foot for batt insulation, reducing whole-home heating and cooling loads by 15% to 20% annually.

Wood framing creates thermal bridging across roughly 25% of a standard exterior wall surface, sapping conditioned indoor air and driving up utility expenses. Adding continuous exterior insulation resolves energy code requirements under International Energy Conservation Code (IECC) standards while cutting ongoing operational heating and cooling loads across United States climate zones.

If you only do one thing: Space Batt-Brackets at 24 inches on center with 5.5-inch bracket depths to achieve continuous R-19 to R-24 thermal performance at the lowest material and labor cost per square foot.

• Bracket material costs: Batt-Brackets start at $122.21 per box, working out to approximately $0.89 per square foot at 24-inch on-center spacing (116 to 136 square feet of coverage per box) or $1.26 to $1.58 per square foot at 16-inch on-center spacing.
• Batt material pairing: Steel-stud-width friction-fit batts (16¼-inch or 24¼-inch widths in mineral wool, fiberglass, or wood fiber) add $1.00 to $2.20 per square foot depending on thickness (3.5-inch R-13–15 up to 7.25-inch assemblies).
• Framing labor reduction: Integrated structural fastening faces eliminate the need for separate wood furring strips or vertical strapping, cutting exterior insulation installation labor by roughly 30% to 50% compared to built-up continuous assemblies.
• Operating cost savings: Continuous exterior insulation breaks the thermal bridge of wood and steel studs, yielding typical heating and cooling energy savings of 15% or more based on U.S. Department of Energy estimates for properly detailed residential envelopes.
• Built-in rainscreen drainage: The bracket profile automatically establishes a ventilated drainage cavity behind exterior siding, saving $0.50 to $1.25 per square foot by removing the need for standalone plastic rainscreen mesh.

• Watch out for: Purchasing standard wood-stud-width batts (15¼ inches or 23¼ inches) rather than commercial steel-stud widths (16¼ inches or 24¼ inches), which causes loose fitting and uninsulated thermal bypass gaps.
• Watch out for: Neglecting the water-resistive barrier (WRB) and air sealing details on the sheathing plane prior to mounting brackets.

Calculate the gross exterior square footage minus window and door rough openings, then request project quotes or order online through InSoFast at (888) 501-7899.

General information only, not medical advice. Decisions about health, treatment or wellbeing should be made with a doctor or other qualified healthcare professional.