When planning for the installation of basement insulation, one of the key questions to consider is the R-Value needed for the project. The “R” in R-value stands for the “resistance of energy flow” of the insulating material. Insulation products with higher R-levels result in greater energy efficiency.
During winter months, less cold air is allowed in from the outside, and more warm air is retained inside the home. The very nature of basements - being underground, exposed to ground water, composed of concrete blocks, and prone to mildew and cold - makes a higher R-value essential to this area of the home. InSoFast insulation panels provide solutions to real problems faced when insulating basements.
Increasing R-Value by Maximizing Insulation’s Effectiveness
While many homeowners will buy products that claim to offer R-values of R-15 or higher, much of this incredible efficiency is lost due to structural and design defects. Wood or steel studs in many basements serve to conduct thermal energy (heat) outside, effectively lowering the R-value. Choosing InSoFast allows homeowners to exceed the efficiency of other traditionally high R-value products because InSoFast panels prevent thermal leakage at stud locations.
The key to preventing loss of heat comes from the composition of the studs. Composed of strong, non-conductive materials sheathed in insulating materials and embedded within the insulating foam, the studs within InSoFast panels prevent the gap that plagues other insulation products. The tongue and groove, interlocking design of the panels also serves to prevent heat loss by sealing any gaps that other insulation products could leave.
Choosing the Right InSoFast Panel
InSoFast panels come in either 2 or 2.5 inches of thickness. The 2 inch option, InSoFast UX2.0, offers an R-value of 8.5; however, the added efficiency of construction allows this material to provide greater energy retention than conventional batt walls with an R-13 value. The EX 2.5 inch option comes in two types, with or without electrical raceways for running circuitry wire. Both of these panels have an R-Value of 10, but they outperform other options with a rating of R-15.
InSoFast makes it easy to further increase the R-value of your basement insulation. Because of the embedded stud within the panel, layering a base foam insulation board over it is simple and sturdy. With a triple layer comprised of InSoFast paneling, regular insulating board, and drywall, you’ll have a complete basement wall with an incredible R-value of 21 or more.
Effective and Fast Installation
While the beauty of choosing InSoFast panels should be clear once you consider the maximized energy efficiency they make possible, you should also remember the sheer convenience factor that comes with the product. The design is such that you’ll only need a saw, Loctite glue, concrete fasteners, a razor knife, and spray foam. In no time, you can complete your entire basement insulation.
From installation to cleanup, InSoFast is easy and lives up to its name – In So Fast. Line up the panels, making sure that they interlock appropriately, and remembering to apply glue on the stud areas of the panel. The construction is such that it will require minimal measurement and cutting.
Much like Legos, this product fits with small adjustments, and any insulation project is easy. Finish with a bit of spray foam in the small gaps and along seams; allow it to cure; and then remove with a razor blade knife. For cleaning purposes, use a bit of static guard spray. The foam particles will lose their natural cling, allowing you to vacuum or sweep them more easily.
With InSoFast panels, you will find the most cost effective and convenient way to incorporate a good R-value for your basement insulation.
